Why is the 'actual distance' different from what I ran?.This is a bit odd, but there's no way of detecting if the Footpod data is real or fake, though the calibration value is normally very close (within a fraction of a percent), with just rounding error discrepancies. The Garmin will record Footpod data if you have the watch set so that the Footpod is active, even if you're not wearing the Footpod at the time.Why do I see Footpod data when I'm not wearing the Footpod?.The GUI version allows this type of adjustment. A good view of a clear sky can also help a little.Ī better approach would be to run a known distance, either on a track or using a known course and calibrate against that known value. That will be a run that is reasonably straight, as twists and turns tend to reduce the GPS accuracy. The best run to use for calibration is a run that has the most accurate GPS data. That is because the Garmin recorded data is based on the Footpod, so it's calibrating the Footpod against itself. If you do not have a GPS signal, such as a treadmill run, then there is no calibration possible and this utility will show that no calibration can be automatically performed.
The biggest flaw in the approach is that it relies on the GPS signal, and GPS is not that accurate itself. The advantage of this utility is that you can use any run to check the calibration and you can run much further. The calibration run is comparing the GPS distance covered with the Footpod reported speed. This is using the same principle as the Garmin calibration run, where you tell the Garmin to calibrate and then run about 1 Kilometer. That should be the same as the foodpod speed if the GPS is accurate and Footpod is calibrated.Ģ.1 Is this different to a Garmin calibration run? By looking at each position that is recorded, you can work out how far you've traveled and how long it took. If the Footpod is active, then the speed according to the Footpod is also recorded. The Garmin devices record your position along with other data such as Heart Rate every few seconds. TCX Exports from Garmin Connectcontain what looks like speed data from the Footpod, but it matches the GPS signal perfectly. The following devices have been tested please let me know if you try it with other devices.įor the calibration run the speed source must be set to Footpod, not GPS.ĭoes not write any speed or distance information from the Footpodto the TCX file.
#Garmin ant agent windows
Fixed issue where Garmin ANT Agent could fail on certain hardware configurations when the program was auto-launched during Windows start.Fixed issue where Garmin ANT Agent did not correctly minimize at program start.
#Garmin ant agent full
Here is a full list of the fixes in this update:
#Garmin ant agent software
To check for updates, right-click the icon in you system tray and select “Check for Software Updates”. Let’s hope this software upgrade tidies up these small glitches! I have noticed a number of issues that although not critical, are quite annoying.
#Garmin ant agent Pc
I have the Garmin ANT+ Agent in the start-up of my PC and laptop.
0 kommentar(er)
